Stoelting SC118 - Manual (Page 13)

5
SECTION 3
INITIAL SETUP AND OPERATION
3.1 OPERATOR'S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; Observe these
rules:
A. Know the freezer. Read and understand the
Operating Instructions.
B. Notice all warning labels on the freezer.
C. Wear proper clothing. Avoid loose fitting garments,
and remove watches, rings or jewelry which could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical cord for maintenance.
Never attempt to repair or perform maintenance on
the freezer until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating condi
tions. Never operate the freezer if unusual or exces-
sive noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the freezer, it is required that the
operator know the function of each operating control.
Refer to Figure 8 for the location of the operating
controls on the freezer.
A. Clean OFF ON Switch
The clean off on switch is a three position switch. In
the clean position only the drive and condenser fan
will run. In the ON position the drive and condenser
fan and compressor will run until the proper consis-
tency is reached, then the compressor will stop and
the drive and condenser fan will continue to run.
B. Mix Low Light
The mix low light will illuminate when the liquid level
in the hopper is less than 2".
C. Standby Serve Switch
The standby switch is a two position switch. In the
standby position mix temperature will be maintained
between 32° and 40°F. In the serve position the
product temperature in the barrel will be determined
by product consistency.
D. Lights Off On Switch
The lights Off On Switch is a two position switch.
When the switch is in the ON position the lights will
illuminate, when the switch is in the off position the
lights will be OFF.
Figure 5. Controls
E. High Pressure Cut Out Switch
The high pressure cut out switch is located under the
right side frame about halfway back. Push up to reset.
Figure 6. Disassembling Freezer
3.3. DISASSEMBLY OF FREEZER PARTS
CAUTION
PLACE THE CLEAN OFF ON SWITCH IN THE OFF
POSITION BEFORE DISASSEMBLING FOR
CLEANING OR SERVICING.
Inspection for worn or broken parts should be made at
every disassembly of the freezer for cleaning or other
purposes. All worn or broken parts should be replaced to
ensure safety to both the operator and the customer and
to maintain good freezer performance and a quality prod-
uct. Frequency of cleaning must comply with the local
health regulations.