Siemens 4010 User Manual
Page 84
80
Gigaset 4010 Comfort, GBR, A31008-G4010-B102-1-7619
anha.fm
11.6.01
Call charges are not dis-
played
Charges per unit = 0
Set call charges per unit
(page 41)
You cannot hear
The key
was
pressed – the micro-
phone is “muted”
Press
S
, to activate
the microphone
The incoming call
number is not displayed
although CLIP is set.
The telephone number
transmission is blocked
The callers must permit
the transmission of
their telephone num-
bers at their network
provider
The ringer/dialling
tone cannot be heard.
You have changed the
telephone cord on
your Gigaset.
Ensure, when pur-
chasing a new cord,
that it has the correct
pin assignment (3-4
assignment of the tel-
ephone leads/EURO
CTR37).
Error beep is generat-
ed (descending tone
sequence)
Wrong input
Repeat the proce-
dure; note the display
and, if necessary, re-
fer to the operating in-
structions
Fault
Possible cause
Solution