Samsung DVD-R4000 - Manual (Page 53)

53
DVD-R4000
Re
fe
re
n
ce
Sound Page
Play
Displays
Remote control
No sound.
Low volume.
Distorted sound. ≥Check the connections. Check the input mode on the amplifier if you have connected one.
≥Turn V.S.S. off if it causes distortion.
5,
41–43
37
Cannot hear the desired
audio type. ≥Press [AUDIO] to select the desired audio type. 23
Cannot switch audio during
stereo or SAP broadcasts. ≥You have used digital connection. Set “Dolby Digital” to “PCM” or connect to other equip-
ment using audio cables (analog connection).
≥You cannot change the audio type when a DVD-R is in the disc tray.
42, 47
—
Play fails to start even when
[1] (PLAY) is pressed.
Play starts but then stops
immediately. ≥Insert the disc correctly with the label facing up.
≥This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and
MP3 discs.
≥The disc is dirty. Clean it.
≥The disc may be badly scratched.
≥You inserted a blank DVD-RAM or DVD-R.
≥Condensation has formed: Wait 1 to 2 hours for it to evaporate.
15
11
50
—
—
—
A title or chapter doesn’t play
when it is selected. ≥Some titles and chapters on DVD-Video are not played when you have changed the ratings
level.
46
Picture distorted during
search. ≥Some distortion is normal. —
Alternative soundtrack and
subtitles cannot be selected. ≥The languages are not recorded on the disc.
≥You may have to use the disc’s menus to select languages. —
17
No subtitles. ≥Subtitles are not recorded on the disc.
≥Turn the subtitles on. —
36
Angle cannot be changed. ≥This function depends on software availability. Angles can only be changed during scenes
where different angles are recorded.
—
You have forgotten your
ratings password. ≥Return the ratings setting to “8”.
While the disc tray is open, press and hold [:/6] and [5/9] on the main unit at the
same time for 5 or more seconds.
—
The display is dim. ≥Go to the Display menu and change the display’s brightness with “FL Display”. 47
“12:00” is flashing on the
unit’s display. ≥The clock is not set. 49
The displayed recording time
and actual recording time
differ. ≥Displayed recording time is based on the number of frames per second. This number is
subject to minute variations. When recording over long periods, these variations may result
in the difference between displayed recording time and actual recording time. This is nor-
mal.
—
The display doesn’t show the
correct time. [MP3] ≥Times may not appear correctly when searching through tracks recorded with a variable bit
rate.
—
The remote control doesn’t
work. ≥[DVD, TV] is not switched to “DVD”. Switch to “DVD” when operating this unit.
≥The remote control and main unit are using different codes. Change the code on the remote
control or main unit.
≥The batteries are depleted. Replace them with new ones.
≥Point the remote control at the remote control sensor on the main unit.
≥Remove obstacles from between the remote control and main unit.
12
45
6
6
—
Cannot operate the
television. ≥Change manufacturer code. Some televisions cannot be operated even if you change the
code.
≥[DVD, TV] is not switched to “TV”. Switch to “TV” when selecting the receiving channel for
the television.
10
12