Sony STR-DG920 - Manual (Page 99)

99 US
Us
ing
the
Re
m
o
te
Selecting a preset channel
1 Press XM to select “XM RADIO”.
2 Press PRESET+ or PRESET – repeatedly to
select the preset channel you want.
You can also press SHIFT, then press
numeric buttons to select the preset channel
you want. Then, press ENT/MEM to enter
the selection.
You can also press TUNING MODE on the
receiver repeatedly to select “PRESET”
then use TUNING +/– to select the preset
channels you want.
Programming the remote
You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses as an example a
case in which a VCR made by a company
other than Sony is connected to the VIDEO 1
IN jacks on the receiver.
Before you begin, note that:
– You cannot change the settings of PHONO.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver and
point the remote towards the
receiver when performing the
following procedure.
1
Press and hold RM SET UP,
then press AV ?/1.
The RM SET UP indicator slowly flashes.
2
Press the input button
(including TV) for the
component you want to control.
For example, if you are going to control a
VCR connected to VIDEO 1 IN, press
VIDEO 1.
The RM SET UP and SHIFT indicator
light up.
If you press the button for a component of
which you cannot program the remote,
such as DMPORT, XM, etc., the RM SET
UP indicator keeps flashing.
Using the Remote
continued