SATO LM400E - Manual (Page 6)

: Use only the designated electrical power and voltage
Use the type of power source indicated on the printer. Different
voltage may cause fire or electric shock.
: Connect ground wire
Make sure to connect the ground wire of the printer to the ground
slot. Failure to do so may cause electric shock.
Warning
: Power cord
Do not attempt to damage, break, or modify the power cord. Also,
avoid placing a heavy object on, heating, or pulling the power cord.
This may damage the power cord causing fire and electric shock.
If the power cord becomes damaged in any way (exposed cable
core, breaking of wire), contact your nearest dealer, service center
or the store where you purchased the printer. Continue use of
damaged power cord may cause fire or electric shock.
Do not attempt to modify, jerk, knot, sharply bend, or otherwise
abuse the power cord. Continue use of damaged power cord may
cause fire or electric shock.
: In case of drop or damage
If the printer was dropped or damaged, turn off the power
immediately, disconnect the power cord from the power outlet, and
contact your nearest dealer, service center or the store where you
purchased the printer. Continue use of the printer in this condition
may cause fire or electric shock.
: Do not use the printer in abnormal condition
In the case of abnormalities such as smoke or foul odors from the
printer, stop using the printer immediately. Continue use of the
printer in this condition may cause fire or electric shock. Turn off
the power immediately, disconnect the power cord from the power