SATO LM400E - Manual (Page 7)

outlet, and contact your nearest dealer, service center or the store
where you purchased the printer. Do not attempt to repair the
printer yourself.
: Do not disassemble
Do not attempt to disassemble or modify the printer. Fire or electric
shock may occur. For service and repair of internal problem,
please contact your nearest dealer or service center or the store
where you purchased the printer for assistance.
Caution
: Do not use in locations with high humidity
Do not place the printer in any places where it will be subjected to
high humidity or condensation.
If condensing, turn off the power switch immediately, stop using it
and dry completely without using any heat producing devices.
Continued use under these conditions may cause electric shock.
: Carrying the printer
Disconnect the power cord from a power outlet before moving the
printer to other places. Leaving it connected and moving the printer
will damage to the cord and connections. This may cause fire or
electric shock.
Do not carry the printer when the label is set. If the label falls and
hits someone, it could cause injury.
When placing the printer on the floor or the table, be careful not to
get your fingers or hands caught in the legs of the printer.
: Power supply
Do not touch the power switch, replace the fuse, or plug-in/unplug
the power cord with wet hands. This may cause electric shock.
: Power cord
Keep the power cord out of any appliances that produce heat. This
may melt the coating of power cord and cause fire or electric