Sanyo CLT-E32 - Manual (Page 44)

[ E 4 2 ] B a s i c s
BASICS
Initially make your call with the pulse dialing mode. Once your call connects, press
* /tone/ . Enter the desired number. These digits will be sent as tone dialing. Once the
call ends, the tone mode is canceled and pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise may
increase. If you pass the range limits of the base unit, you will hear a beep and see
Ou t of
R a ng e on the display, and then the handset returns to standby mode. You may return to the
call if you move your handset within the range limits of the base and press talk/flash or
speaker within 30 seconds.
Notes:
• The tone feature only applies when the dial mode is set to pulse.
• This special number can be stored in a memory location. This is referred to as Chain Dialing
(see page E56).
UP383BA_0.book Page 42 Thursday, May 26, 2005 10:48 AM