Sony DVS-V3232B/V3232M - Manual (Page 116)

5-44
ROUTING SWITCHER SYSTEM (E)
5-2. Setting Items of the Secondary Station
LEVEL MODE *1
SINGLE = Single level selection
MULTI = Multiple level selection
DEST SELECTION *2
DISABLE = Change of destination from the panel is
prohibited.
ENABLE = Change of destination from the panel is
allowed.
ILLUMINATION LEVEL *3
Brightness of the button indicator : 1 (dark) to 8 (bright)
MONITOR DESTINATION *3
Enter the name of the destination to be monitored (when
the MONI button is selected).
SOURCE OFFSET *3
0 = Use the same source as the destination to be monitored.
1 to 1023 = Use the source at the specified offset.
CONTROL LEVELS *3
When you want to select any specific level from remote
control unit, move the cursor to the desired level and
press [Enter]. (When you want to select level-3, move
the cursor to the third “ _” position and press [Enter].)
“ _” = : Level selection will not be performed.
Other than “ _” : A signal will be switched at the level.
When all indications show “ _”, a signal is switched at
the level which is set by the primary station.
* 1 : It is only applicable to BKS-R3210/R3216.
* 2 : It is only applicable to BKS-R1607/R1617.
* 3 : It is only applicable to BKS-R3216/R1617/R1618/R3219/R3220/R1621.
Setting Procedure
1. Select the menu item [Z].
2. The cursor appears in “DISPLAY MODE = 1”.
Move the cursor to an arbitrary mode and press
[Enter] establishes the input mode.
3. Enter a number to select using the ten-keys.
When [Enter] is pressed to confirm the input number,
the cursor moves to the next setting item.
When you do not want to change the default value, do
not input any number, but press [Enter].
Example of Setting Screen
4. Set the respective items in the same way as the steps 2
and 3.
However, set “PANEL MODE” (setting the mother
and daughters panels) as follows.
SONY ROUTING SYSTEM SETUP MENU BKS-R3220 V1.03 STATION NUMBER 2
SET PANEL STATUS
DISPLAY MODE = 1 1:STATUS 2:PROMPT
PROTECT MODE = 2 1:ON AIR 2:NORMAL 3:FLEXIBLE 4:FLEX & OA
PHANTOM PROTECT = 1 1:PART PROT 2:FULL PROT 3:BUTTON LINK
PANEL MODE = 1 1:STAND ALONE 2:MOTHER 3:DAUGHTER
PANEL LAYOUT = 1 1:TYPE + NUM. 2:BPS 3:KEYPAD *:UNRELATED
LEVEL MODE = 1 1:SINGLE 2:MULTI *:UNRELATED
DEST SELECTION = * 1:DISABLE 2:ENABLE *:UNRELATED
ILLUMINATION LEVEL = 8 1-8:MIN-MAX
MONITOR DESTINATION = .......
SOURCE OFFSET = 0000
CONTROL LEVELS = --------
BLOCK & MOTHER STATION LIST
BLOCK 1 = ....... | BLOCK 6 = .......
BLOCK 2 = ....... | BLOCK 7 = .......
BLOCK 3 = ....... | BLOCK 8 = .......
BLOCK 4 = ....... | BLOCK 9 = .......
BLOCK 5 = ....... | BLOCK10 = .......
Ctrl-E:MENU Ctrl-D:RETURN