7. initialization of table data – Sony DVS-V3232B/V3232M User Manual
Page 127
5-55
ROUTING SWITCHER SYSTEM (E)
5-7. Initialization of Table Data
5-7. Initialization of Table Data
There are five ways of initializing the table data. Note that the way to be used depends on which item is
initialized.
5-7-1. Initializing Procedure and Corresponding Items
DVS-V3232B/V6464B :
Initializing Procedure
Corresponding Menu Items
1
1. Set the test switch (S3) on the CPU-149 board to “D”.
All items of the primary and secondary stations.
2. Press the reset switch (S5).
2
1. Set the test switch (S3) on the CPU-149 board to “C”.
[W : SYSTEM STATUS LOG]
2. Press the reset switch (S5).
3
Select the menu item [K : RESET TO DEFAULT TABLE]
All items of the primary station excluding the
of the primary station and press
[Y]
.
following 4 items.
.
[H : SET GLOBAL PHANTOM]
.
[N : SET DESCRIPTION NAME GROUP]
.
[O : SET TIE LINES]
.
[W : SYSTEM STATUS LOG]
4
Select the menu item [K : reset To default table]
All items of the secondary station excluding
of the secondary station and press
[Y]
.
the crosspoint data.
5
Select the menu item [U : SELECT REMOTE PROTOCOL]
[U : SELECT REMOTE PROTOCOL]
of the secondary station and press
[F2]
(DEFAULT).
BKPF-R70 :
Initializing Procedure
Corresponding Menu Items
1
1. Set the test switch (S5) on the CPU-256 board to “D”.
All items of the primary and secondary stations.
2. Press the reset switch (S1).
2
1. Set the test switch (S5) on the CPU-256 board to “C”.
[W : SYSTEM STATUS LOG]
2. Press the reset switch (S1).
3
Select the menu item [K : RESET TO DEFAULT TABLE]
All items of the primary station excluding the
of the primary station and press
[Y]
.
following 4 items.
.
[H : SET GLOBAL PHANTOM]
.
[N : SET DESCRIPTION NAME GROUP]
.
[O : SET TIE LINES]
.
[W : SYSTEM STATUS LOG]
4
Select the menu item [K : reset To default table]
All items of the secondary station excluding
of the secondary station and press
[Y]
.
the crosspoint data.
5
Select the menu item [U : SELECT REMOTE PROTOCOL]
[U : SELECT REMOTE PROTOCOL]
of the secondary station and press
[F2]
(DEFAULT).