Sony HT-FS3 - Manual (Page 60)

60 GB
• If you resume playback of a disc when
volume is maximum, there may be no sound.
In this case, turn down the volume, turn off
the system and turn on again.
Sound is interrupted or there is noise.
• Check the output audio formats supported
by this system on page 62.
There is no picture or an unclear picture
appears on the TV screen.
• Check that the TV is selected correctly.
• Set the TV to the appropriate input mode.
• Move your audio components away from the
TV.
• If a video signal other than those supported
by the system is input, the image may be
distorted.
The source image input to the HDMI jack on the
subwoofer is not output from the TV.
• Check the HDMI connection.
• Depending on the playback component, you
may need to set up the component. Refer to
the operating instructions of each
component.
• Use a High Speed HDMI cable. If you use a
Standard HDMI cable, 1080p images may
not be displayed properly.
Control for HDMI
The Control for HDMI function does not work.
• Check the HDMI connection (page 12).
• Make sure “CTRL: HDMI” is set to “ON” in
AMP menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on the
connected component. Refer to the
operating instructions supplied with the
connected component.
• If you change the HDMI connection, or
connect/disconnect the AC power cord
(mains lead), or if there is a power failure,
repeat the procedures of “Preparing for the
“BRAVIA” Sync” (page 29).
• The system may not work correctly if you
select a component that is not compatible
with the Control for HDMI function on the
TV side.
No sound is output from the system and the
TV’s speaker.
• Check the volume of the system and the TV.
• Select the input of the system correctly.
The sound is output from both the system and
the TV.
• If the Control for HDMI function is set to off,
or the selected component is not compatible
with the Control for HDMI function, turn off
the sound of the system or the TV.
The System Power Off function does not work.
• Change the setting of the TV to turn
connected components off automatically
when you turn off the TV. For details, refer
to the operating instructions of the TV.
An image does not appear on the TV.
• Check whether HDMI IN and HDMI OUT
are connected correctly.
A message stating that the output method has
changed from the system speaker to the TV
speaker appears on the TV screen.
• When the DMPORT function is selected, the
System Audio Control function does not
work (page 32).
When the system is in standby mode, there is
no image or sound on the TV.
• When the system is in standby mode, image
and sound are output from the HDMI
component selected the last time you turned
off the system. If you are enjoying other
component, play the component and
perform the One-Touch Play operation, or
turn on the system to select the HDMI
component you want to enjoy.
• Make sure “POWER SAVE” is set to “OFF”
in the AMP menu if you connect
components not compatible with the
“BRAVIA” Sync to the system (page 34).