Sony HT-FS3 - Manual (Page 63)

63 GB
Ad
dition
al I
n
fo
rm
atio
n
HDMI section
Connector HDMI TM Connecter
Video inputs/outputs BD, DVD, SAT/CATV:
640 × 480p@60 Hz
720 × [email protected]/60 Hz
1280 × [email protected]/60 Hz
1920 × [email protected]/
60 Hz
1920 × [email protected]/
60 Hz
720 × 576p@50 Hz
1280 × 720p@50 Hz
1920 × 1080i@50 Hz
1920 × 1080p@50 Hz
1920 × 1080p@24 Hz
Audio inputs BD, DVD, SAT/CATV:
Linear PCM 7.1ch/
Dolby Digital/DTS
Tuner section
System PLL quartz-locked digital
synthesizer
FM tuner section
Tuning range
87.5 – 108.0 MHz
(50 kHz step)
Antenna (aerial) FM wire antenna (aerial)
Antenna (aerial) terminals 75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
531 kHz – 1,602 kHz (with
the interval set at 9 kHz)
Antenna (aerial) AM loop antenna (aerial)
Intermediate frequency 450 kHz
Speakers (SS-FS3)
Speaker system Full range, Bass reflex
Speaker unit 65 mm cone type
Rated impedance 4 ohms
Dimensions (approx.) 102 mm × 163 mm × 77
mm (with foot) (w/h/d)
Mass (approx.) 0.55 kg
Subwoofer (SA-WFS3)
Speaker system Subwoofer, Bass reflex
Speaker unit 130 mm cone type
Rated impedance 2 ohms
Dimensions (approx.) 212 mm × 374 mm × 364
mm (w/h/d)
Mass (approx.) 8.9 kg
General
Power requirements 220 – 240 V AC, 50/60 Hz
Power consumption
On: 95 W
Standby mode: 0.3 W (when “CTRL: HDMI”
and “S-AIR STBY” are set
to “OFF.”)
Power output
(DIGITAL MEDIA PORT) DC OUT: 5 V, 700 mA
Design and specifications are subject to change without
notice.
• Standby power consumption 0.3 W.
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Over 85 % power efficiency of amplifier block is
achieved with the full digital amplifier, S-Master.