Sampo DVE-560 - Manual (Page 15)

13
INITIAL SETTING
Press the SETUP button on the remote control into the
initial setting, while the OSD for initial setting will be
displayed as follows,
Four items are available in initial setting, which are
1. General Setup : general function setting for this unit
2. Speaker Setup : speaker output mode setting
3. Digital Audio Out : digital audio output setting
4. Preferences : your personal preferences
p General Setup
There are seven items in the general setup, which are
TV Display
This DVD player provides three TV video modes :
1 4:3
4:3 pan & scan video output for normal TV set
1 4:3
4:3 letter box video output for normal TV set
1 16:9
16:9 video out for wide screen TV set
Angle Mark
During playback of a title with multi-angle section, the
message " " will appear on the lower corner of the
screen.
1 When ANGLE MARK is set at "ON", the angle mark
always stays on the screen until the end of the
playback title.
1 When ANGLE MARK is set at "OFF", the angle mark
also appears on the screen but just lasts 3 seconds.
SETUP MENU – MAIN PAGE
4GENERAL SETUP
4SPEAKER SETUP
4DIGITAL AUDIO OUT
4PREFERENCES
3EXIT SETUP
GOTO SPEAKER SETUP PAGE
--GENERAL PAGE—
TV DISPLAY
ANGLE MARK >>
ON
OSD LANGUAGE OFF
AUDIO OUTPUT
VIDEO OUT
SCART OUT
SCREEN SAVER
ANGLE MARK ON/OFF
--GENERAL PAGE—
TV DISPLAY >>
ANGLE MARK
OSD LANGUAGE
AUDIO OUTPUT
VIDEO OUT
SCART OUT
SCREEN SAVER
GENERAL SETUP
4:3
4:3
16:9
--GENERAL PAGE—
TV DISPLAY >>
ANGLE MARK
OSD LANGUAGE
AUDIO OUTPUT
VIDEO OUT
SCART OUT
SCREEN SAVER
GENERAL SETUP
4:3
4:3
16:9