Sampo DVE-560 - Manual (Page 24)

22
Advanced Operation
p Repeated playback
Whenever the 1/ALL button is pressed, the repeated
playback is triggered and the message OSD is changed in
circles of “ 1”, “ ALL”, and “ OFF”.
1 “ 1”
ü Trigger the repeated playback of a chapter for a
DVD disc.
ü Trigger the repeated playback of a track for a CD
disc or a VCD disc.
1 “ ALL”
ü Trigger the repeated playback of a title for a DVD
disc.
ü Trigger the repeated playback of all disc for a CD
disc or a VCD disc.
1 “ OFF”
Resume the normal playback.
p A-B Repeated playback
Do repeated playback between any two points of a track
or a chapter, which you can set randomly.
Press the A-B button during playback to set the
beginning point (A) at the current playback time, while the
OSD message “A “ is shown on the right lower screen
corner.
Press the A-B button again to set the end point (B) at
the current play time, while the “A B” OSD message is
shown. At the mean time, the repeated playback between
the two points, A and B, starts.
Pressing the A-B button again, the normal playback is
resumed, while the OSD message “ OFF” is shown.
p Random playback (only for a VCD with
PBC off or a CD-DA)
1 Press the
RANDOM button to trigger the random
playback, while the OSD message “ RANDOM ON” is
displayed and lasts few seconds. During the random
playback, a track will be chose randomly to playback
after another track is finished.
1 Pressing the
RANDOM button again, the normal
playback is resumed, while the OSD message
“RANDOM OFF” is displayed and lasts few seconds.
p Program playback
The program playback is only available for a CD-DA or a
VCD with PBC off.
Track program
1. Press the STOP button to stop the playback.
2. Press the PROGRAM to program the tracks for
program playback, while the following OSD message is
displayed,
Where “Pxx:yy” denotes the yyth track in the disc is
programmed at the xxth position
3. Press the numbers to program
For example: To program the 2 nd track at the 1 st position,
the 4 th one at the 2 nd position, and the 6 th on at the 3 rd
position, key digit 2 , digit 4 , digit 6 sequentially,
while the OSD message changes as follows,
i
The number bigger than 10 must be keyed by using
[+10] additionally. For example, “22” is keyed in by
pressing [+10] twice and then [2] once.
i The maximum program capability is 99 tracks.
PROGRAM P00:00