How to operate your cordless sweeper, Nettoyage du plateau à poussière, Avertissement – Shark V1730 User Manual

Page 6

Advertising
background image

4

HOW TO OPERATE YOUR CORDLESS SWEEPER

1. Before using, please ensure that the cordless sweeper has been initially

charged for 20 hours
Your cordless sweeper will only operate properly when the batteries are fully
charged. Your sweeper will operate for varying lengths of time on a full charge. This
will depend upon the type of surface being cleaned. (Longer operating time on bare
floors vs carpets.)

2. Push the On/Off switch to operate the unit. To turn off, press switch again.(Fig.4)

CAUTION: Any electronic or electrical appliance should not be

stored in or exposed to areas of high heat or humidity.
Do not store your cordless sweeper close to stoves,
radiators, furnaces or in a bathroom or bathing area.

3. To release the handle to a comfortable position, apply pressure to the top of the

sweeper head with your foot while pulling back on the handle.(Fig. 5)

4. To change the speed of the sweeper, press on the speed control button. As you press

on it, the speed indicator light will change. If one light lights up, then you have the low
speed; two lights, medium speed; three lights, high speed.

5. If the brush roll will jam, all the lights will flash. If this occurs, please switch the

"On/Off" switch

Fig. 5

Fig. 4

49

NETTOYAGE DU PLATEAU À POUSSIÈRE

Pour un meilleur rendement, videz le plateau après chaque usage.

1. Retirez le plateau tout droit hors du côté de la balayeuse (Fig. 2)

2. Videz le contenu du plateau (Fig. 3). Si vous le désirez, rincez le plateau à l’eau

pour le nettoyer mais séchez-le complètement avant de le remettre dans la
balayeuse.

3. Remettez le plateau dans la balayeuse.

4. De temps à autre, retirez le couvercle transparent de la brosse et retirez toute

accumulation de peluches, de cheveux ou de fibres sur la brosse rotative. Pour
enlever le couvercle transparent, agrippez le couvercle à partir du bas, tirez-le
vers l’extérieur jusqu’à ce qu’il sorte des fentes du bas et des languettes situées
dans le haut de la balayeuse (Fig. 4, Fig. 5).

Fig. 3

Fig. 4

Fig. 5

Fig. 2

AVERTISSEMENT :

Évitez de mettre la balayeuse

accidentellement en marche pendant son nettoyage. Ne
nettoyez pas la balayeuse pendant qu’elle se recharge.

unit off, clear obstruction from brush bar and then depress on/off switch to

start the sweeper again.

Advertising