Shark V1730 - Manual (Page 8)

6
4. When the sweeper on/off switch is depressed the sweeper will slowly come up to
speed. This is done to optimize the life of all components of the sweeper and is
normal.
5. When first started, the sweeper will start in the highest speed “III” to prevent
overloading the unit when starting on heavy carpets. Other speeds can then be
selected by depressing the speed selector switch.
6. For best cleaning performance, use speed “I” (low) on hard surfaces, speed “II”
(medium) on low carpets/rugs, and use speed “III” (high) on deeper carpets. These
are guide lines and you will find the optimum speed settings for your surfaces and
debris to be picked up through use and experience.
7. The sweeper will automatically try to maintain speeds on all surfaces. The unit
may appear to be pulsing during use to maintain it’s speed, this is normal. If this
occurs, please select the next highest speed to gain optimum performance.
8. To protect your sweeper and it’s components, the sweeper is provided with an
electronic overload circuit. If something were to jam or overload the brush bar system,
the units speed indicators will flash and the unit will stop operating, this is normal. If
this occurs , switch the unit off, clear the obstruction from the brush bar and then
depress the On/Off switch to start the sweeper again
NOTE: If, when you place the sweeper to recharge and the charging indicator light
does NOT illuminate, then press the On/Off button once to turn the sweeper
off. The charging indicator light should now light up.
NOTE: Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
IMPORTANT: To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely
re-charged at least once a month.
CAUTION
• Use only with the battery pack supplied with the unit. (Item # X9730)
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.
• Battery must be recycled or disposed of in accordance with local regulations at
the end of it's service life. Please consult your Yellow Pages or local recycling
center for more information.
STORING THE CORDLESS SWEEPER
Your cordless sweeper may be stored by using the slot on the back of the upper handle
and hanging it from a screw secured to a wall or other vertical surface. Use a #6 flat or
pan head screw with the appropriate hardware for the surface that the sweeper will be
mounted on, (i.e. gyproc). Allow the screw head to extend a approximately 3/16" from the
mounting surface. Always empty your sweeper before hanging up for storage.
BALAYEUSE À MAIN SANS FIL
3,6 volts CC
47
1. Commutateur marche/arrêt
2. Voyant de recharge
3. Plateau à poussière
4. Couvre-brosse transparent
5. Brosse rotative
6. Prise de recharge
7. Manche pivotant
8. Adaptateur de recharge
REMARQUE : Lors de l’envoi, les piles de la balayeuse à main
sans fil ne sont pas chargées. Vous devrez charger les piles pendant
20 heures avant l’usage initial. Utilisez des piles de rechange XSB705
seulement.