Sony DVP-NC650V - Manual (Page 61)

61
S
ound Adjus
tme
nts
VIRTUAL MULTI REAR
Uses sound imaging to create an array of
virtual rear speakers from a single pair of
actual rear speakers. The virtual speakers are
reproduced as shown in the illustration
below. The position of the virtual rear
speakers differs according to “REAR” or
“SIDE” setting of the rear speakers (page 86).
VIRTUAL MULTI DIMENSION
Uses sound imaging to create an array of
virtual rear speaker positions higher than the
listener from a single pair of actual rear
speakers.
This mode creates five sets of virtual
speakers surrounding the listener at
approximately a 30
°
angle of elevation. The
effect differs according to “REAR” or
“SIDE” setting of the rear speakers (page 86).
z You can select “SURROUND” directly by
pressing SURROUND. Each time you press the
button, the item changes. If you select any setting
other than “OFF,” the SURROUND indicator on the
player lights up.
Notes
• To enjoy the multichannel audio through the 5.1CH
OUTPUT jacks, correctly set each speaker position
and distance. For details on setting each speaker, see
page 86.
• When you select an item, the sound cuts off for a
moment.
• When the playing signal does not contain a signal for
the rear speakers (page 57), the surround effects may
be difficult to hear.
• When you select “TVS DYNAMIC,” “TVS WIDE,”
“TVS NIGHT”, or “TVS STANDARD,” the player
does not output the sound from the center speaker.
• When you select one of the surround modes, turn off
the surround setting of the connected TV or
amplifier (receiver).
L
LS RS
R
L R
LS RS
SIDE
REAR
L: Left front speaker
R: Right front speaker
LS: Left rear speaker
RS: Right rear speaker
: Virtual speakers
LS RS
L R
L R
LS RS
SIDE
REAR
continued ,