Sony DVP-NC650V - Manual (Page 76)

76
6
Press H on the player to start playing.
Playback starts and the display shows the
current disc and track numbers and the
playing time of the track. While the
MEGA CONTROL button on the front
panel is lit, you can control CD changer
with the controls on the player as follows:
To control the player again
Press MEGA CONTROL on the player.
The MEGA CONTROL button on the player
turns off and you can control the player.
Notes
• Connect only a Sony 5/50/200/300/400 CD changer
to MEGA CONTROL jack.
• Set CONTROL A1 or CONTROL A1II in the setup
menu of the CD changer so that it matches the
connection made above. Refer to the operating
instructions supplied with the CD changer.
• You cannot locate a particular point on a CD’s track
using the controls on the player.
• Depending on the CD changer, some controls on the
player may not operate the CD changer as they do
the player.
• You cannot control the player when the MEGA
CONTROL button on the front panel is lit.
• The player will not enter Resume Play after the
MEGA CONTROL button on the front panel has
been turned on and off.
• You cannot control the CD changer right after
turning on the player or connecting the CD changer.
Wait a few seconds until the player recognizes the
CDs.
• When the MEGA CONTROL button is lit, you
cannot use the Control Menu.
To Operation
Select a disc during
playback Press the number
button on the remote
and ENTER, or
X/
x and ENTER
Stop Press x
Pause Press X
Resume play after pause Press X or H
Go to the next track or
scene in continuous play
mode Press >
Go back to the preceding
track or scene in
continuous play mode Press .