Smart Technologies SMART Board D600 - Manual (Page 21)

13 | CHAPTER 2 – INSTALLING AND SECURING YOUR SMART BOARD
INTERACTIVE WHITEBOARD
If you’re installing a SMART Board
685/D685 or 690/D690 interactive whiteboard,
space your wall-mounting brackets’ innermost
screw holes 4" (10.2 cm) or 6" (15.3 cm) apart
respectively, and then mark the location of the
10 mounting holes on the wall, as illustrated.
WARNING
Use two wall-mounting brackets to install
your SMART Board 685/D685 or
690/D690 interactive whiteboard.
Using only one bracket could result in
personal injury or product damage.
3. Use the Phillips No. 2 screwdriver to secure an
included self-tapping wall anchor at each mark.
CAUTION
Do not use a hammer to secure these
anchors.
If you’re unable to screw an anchor flush to the
wall, you might have encountered a stud. If this
is the case, you don’t need to use an anchor in
this location. The stud will provide adequate
support for the screw that secures the bracket
to the wall.
NOTES
–
For a concrete wall, drill holes at the marks, and then insert concrete
anchors (not included) into the holes.
– If necessary, stand on a stepladder so that you can secure these wall
anchors flush to the wall.
4. Using the screwdriver, secure the wall-mount
bracket to the self-tapping wall anchors with the
included screws.
5. With the help of another person, temporarily
hang your interactive whiteboard on the center
of its wall-mounting bracket.
685/D685: 4" (10.2 cm)
690/D690: 6" (15.3 cm)