Smart Technologies SMART Board D600 User Manual
Page 4
ii
|
IMPORTANT INFORMATION
•
To reduce the risk of fire or electric shock, do not expose your SMART Board
interactive whiteboard to rain or moisture.
•
Use two wall-mounting brackets to install your SMART Board 685/D685
or 690/D695 interactive whiteboard. Using only one bracket could result in
personal injury or product damage.
•
Do not mount your SMART Board 600 or D600 series interactive whiteboard
on a SMART Board 500 series interactive whiteboard floor stand. Using an
older stand could result in personal injury or product damage. Only FS670
stands are certified for use with 660, 680 or D680 models.
•
Do not mount a SMART Board 685, D685, 690 or D690 interactive whiteboard
on a floor stand. Do not modify either your interactive whiteboard or a floor
stand to make them compatible. Using a large interactive whiteboard with a
small stand creates a tipping hazard.
•
Do not mount the optional USB Audio System speakers on a SMART Board
640 interactive whiteboard mounted on an FS640 stand. Using the speakers
with the small stand creates a tipping hazard.
•
Move your floor stand-mounted SMART Board interactive whiteboard with
care. Before moving your floor stand-mounted interactive whiteboard, lower
your interactive whiteboard to Position 2, and then proceed with care. Quick
stops, excessive force and uneven surfaces might cause your interactive
whiteboard to overturn. Before moving a floor stand, make sure that the
anti-tip feet are retracted or locked in the up position.
•
Do not stand (or allow children to stand) on a chair to touch the surface of
your SMART Board interactive whiteboard. Instead, remount the product at
the appropriate height, or use a SMART height-adjustable floor stand.
•
Do not climb (or allow children to climb) on your wall- or floor
stand-mounted SMART Board interactive whiteboard.
Climbing on your interactive whiteboard or projector boom, or
riding on your floor stand, could result in personal injury or
product damage.
•
There are no user-serviceable parts inside the pen tray. Only qualified
personnel should disassemble the pen tray’s printed circuit boards, and this
procedure must be done with proper electrostatic discharge (ESD) protection.
•
If you are using an RS-232 serial expansion module, a wireless Bluetooth®
connection expansion module or a USB audio system, use only the power
supply included with that product. These products do not use the same power
supplies. Using the wrong power supply might create a safety hazard or
damage the equipment. If in doubt, refer to the specification sheet for your
product to verify the power supply type.