Smart Technologies SMART Board D600 - Manual (Page 22)

14 | CHAPTER 2 – INSTALLING AND SECURING YOUR SMART BOARD
INTERACTIVE WHITEBOARD
Aligning Your Interactive Whiteboard with Your Projector
If your projector is installed in a fixed location, align your interactive whiteboard
to the projected image before you secure the L-shaped brackets. A correctly aligned
image fits squarely on your interactive whiteboard’s screen. Each side of the projected
image should extend almost to the edge of the display surface.
IMPORTANT
For SMART Board D600 series interactive whiteboards, it is important to align
your interactive whiteboard and projector correctly so that the projected image
divider in dual-user mode in SMART Notebook software aligns with the physical
center of your interactive whiteboard. The actual divider will always be in the
physical center of your interactive whiteboard, regardless of where your projected
image falls.
To align your
interactive whiteboard
with your projector
1. Install or position your projector on a projector platform or stand if necessary,
and then turn it on and point the lens of your projector at the center of your
interactive whiteboard’s screen.
2. Make fine adjustments to the image size, level and focus of the projected image,
following your projector manufacturer’s instructions.
3. Slide your interactive whiteboard sideways on its bracket to align it with the
projected image.
4. Repeat steps 2 and 3 until your interactive whiteboard is properly aligned.
Completing Your Installation
Refer to the following procedure to finish installing your interactive whiteboard.
To complete your
installation
1. Below the bottom frame, you’ll
find two L-shaped metal
brackets. In the center of each
bracket there is a metal tab.
Push this tab back until it
contacts the wall, and then
mark the location of the
mounting holes with
your pencil.