Smart Technologies SMART Board D600 - Manual (Page 16)

8 | CHAPTER 2 – INSTALLING AND SECURING YOUR SMART BOARD
INTERACTIVE WHITEBOARD
Environmental Requirements
Before installing your interactive whiteboard, review the following environmental
requirements.
Environmental
Requirement
Parameter
Operating temperature 41°F to 95°F (5°C to 35°C)
Storage temperature -40°F to 120°F (-40°C to 50°C)
Humidity • 5% to 80% relative humidity, non-condensing
• Humidity above 80% can cause slight wrinkling
in the screen surface sheet. The wrinkles disappear
when the humidity lowers.
Water and fluid
resistance • Intended for indoor use only. Doesn’t meet any
salt-spray or water ingress requirements.
• Don’t pour or spray liquids directly onto your interactive
whiteboard or any of its sub-components. These liquids
can get into areas where they could damage sensitive
electronic components. See Keeping the Writing Surface
Clean on page 33 for detailed instructions on cleaning
your interactive whiteboard.
Dust • Moderate dust. Intended for use in office and classroom
environments. Not for industrial use where heavy dust
and pollutants can cause malfunctions or impaired
operation.
• Designed for pollution degree 1 (P1) as per EN61558-1,
which is defined as “No pollution or only dry
non-conductive pollution.”
Electrostatic discharge
(ESD) • Designed to withstand electrostatic shock
• EN61000-4-2 severity level 4 for direct and indirect ESD
• No malfunction or damage up to 15kV (both polarities)
with a 330 ohm, 150 pF probe (air discharge)
• Unmated connectors meet no malfunction or damage up
to 8kV for direct (contact) discharge
Conducted and
radiated emissions EN55022/CISPR 22, Class B