Smart Technologies SMART Board D600 - Manual (Page 5)

iii | IMPORTANT INFORMATION
CAUTION
•
If you need to lean your interactive whiteboard against a wall before you
mount it, make sure that it remains in an upright position, resting on its pen
tray brackets, which are designed to sustain your interactive whiteboard’s
weight.
• Do not rest your interactive whiteboard on its side or on the top of its frame.
• Do not add any extra weight or excessive pressure to a wall-mounted
interactive whiteboard or its pen tray. SMART designed the brackets
to support only the weight of your interactive whiteboard during normal use.
• For operating safety and to prevent damage to your interactive whiteboard,
connect its USB connector only to a computer that has a USB compliant
interface and that bears the USB logo. In addition, the USB source computer
must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA
and/or UL mark(s) for CSA/UL 60950.
• If dust or small items prevent pen tray buttons from being pressed or cause
constant button contact, remove the obstructions carefully.
• When transporting your SMART Board interactive whiteboard, repack it with
as much of the original packaging as possible. This packaging was designed
with optimal shock and vibration protection.
• Do not allow excess glass cleaner to flow into the crack between the lower
frame and the writing surface, or into the pen tray slots.
Other Precautions
If you own a SMART product other than a SMART Board 600 or D600 series
interactive whiteboard, refer to the installation manual for your product for relevant
warnings and maintenance instructions.
To ensure operating safety and to prevent product damage, observe the following
precautions.
• Don’t set up or use your interactive whiteboard in an area with excessive levels of
dust, humidity or smoke.
• If your SMART Board interactive whiteboard requires replacement parts,
make sure that the service technician uses replacement parts specified by
SMART Technologies or parts with the same characteristics as the original.
• Be aware that security cable locks aren’t designed to be a solid protection
measure because the lock can be torn out. However, potential thieves might be
reluctant to try to sell a product with a broken security cable lock hole, which
would readily identify it as a stolen item.