Smart Technologies SMART Board D600 - Manual (Page 55)

47 | CHAPTER 5 – TROUBLESHOOTING YOUR SMART BOARD INTERACTIVE
WHITEBOARD
Troubleshooting Tips
Try the troubleshooting tips in this table if the Ready light indicates that your
interactive whiteboard is operating normally, but you’re still experiencing problems.
Symptom/Observation Cause Solution
There’s no image projected
on your interactive
whiteboard’s screen, or a
“No Input” message
appears. Your projector isn’t
receiving a video signal. • Check the video cable
connections.
• Check that the correct
video input is selected
on your projector.
• Make sure that your
projector is on and that
it’s connected to a
power source.
• If you’re using a laptop
computer, switch the
external video
connection on. Refer to
your laptop’s user’s
guide for more
information.
Your computer is in
standby mode. Move the mouse or touch
any key on your keyboard
to bring your computer out
of standby mode.
Your computer is off. Turn on your computer (or
press your computer’s
reset button), and then log
on as usual.
The projected image is
blurry, too large or doesn’t
completely fill your
interactive whiteboard’s
screen. Your projector’s position,
zoom and focus settings
aren’t adjusted. Adjust your projector’s
position, zoom and focus
settings. Refer to your
projector’s manual for
more information.
Your computer’s video
resolution settings don’t
match your projector’s
native resolution. Consult your projector’s
manual for the correct
video resolution, and then
go to Windows Control
Panel or Mac System
Preferences to change the
video resolution to match
your projector.