Sherwood D-480 - Manual (Page 13)

When this unit is connected to a Sherwood DIGI LINK CD player controlled remotely by the DIGI LINK
system, the CD Synchro record function can be operated.
Before starting CD synchro recording, adjust the recording level and the balance.
13
RECORDING A CD AUTOMATICALLY
Repeat steps 1,2,3 and 4 of “RECORDING”
Procedure.
1
According to the tape length, edit the
tracks to be recorded on the CD player
referring to the operating instructions of
that.
2
Start CD syncro recording.
3
The CD is selected automatically on the amplifier DIGI LINK receiver.
If 8 seconds elapses after starting recording, the CD player starts play automatically.
NOTE
Only when the erase protection taps on the cassette tapes are in place, CD synchro record function will be
operated.
During CD synchro recording, if other program source on the receiver is selected, the unit stops CD
synchro recording and starts recording the selected program source.
DUBBING FROM DECK B to DECK A
Open the cassette door by pressing the
EJECT button and load a blank cassette
tape into DECK A and prerecorded
cassette tape into DECK B.
1
Select the reverse mode
2
ENGLISH
: Recording of a single side.
: Recording of both sides.
B C
NORM HIGH
SYN MPX MIN SEC
RELAY
REC
P
CD
M
REC
L
R
dB - 00 -20 -10 -6 -3 0 +3 +6
CD SYN REC
REVERSE