Sony CMT-CP33MD - Manual (Page 13)

13
Basic Operations
Tips
• When you want to record on the reverse side, press
TAPE nN to light up the left indicator in step 6.
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side.
• When you want to reduce the hiss noise in low-
level, high-frequency signals, press DOLBY NR
after step 5 so “;” appears in the display.
Note
If “Cannot SYNC” appears, a disc or a tape is not
loaded or you cannot record on that tape (see page
80).
Recording on an MD and a
tape at the same time
1
Perform step 1 of “Recording on an
MD” (see page 10) and steps 1 to 3 of
“Recording on a tape” (see page 12).
2
Press SYNCHRO REC repeatedly until
“DUAL SYNC” appears.
3
Perform steps 5 to 7 of “Recording on a
tape.”
To stop recording
Press CD x, MD x or TAPE x.
Tips
• Even if the MD or the tape ends part-way through
the recording, the other continues recording.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side. In this case, the entire
track may also be recorded again on the MD.
Note
If “Cannot SYNC” appears, a disc or a tape is not
loaded or you cannot record on that tape (see pages
79 and 80).