77 tape deck, Optional components, Tuner – Sony CMT-CP33MD User Manual

Page 77

Advertising
background image

Additional Information

77

Tape Deck

The tape does not record.

• No cassette is inserted. Insert a cassette.
• The tab has been removed from the cassette.

Cover the broken tab with adhesive tape (see
page 73).

• The tape has wound to the end.

The tape does not record or play, or there
is a decrease in sound level.

• The heads are dirty. Clean them.
• The record/playback heads are magnetised.

Demagnetise them (see page 73).

The tape does not erase completely.

• The record/playback heads are magnetised.

Demagnetise them (see page 73).

There is excessive wow or flutter, or the
sound drops out.

• The capstans or pinch rollers in the tape deck

are dirty. Clean them using a cleaning cassette
(see page 73).

Noise increases or the high frequencies
are erased.

• The record/playback heads are magnetised.

Demagnetise them (see page 73).

Optional components

There is no sound.

• Refer to General item “There is no sound” on

page 74 and check the condition of the
system.

• Connect the component properly (see

page 69) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the

way.

• Turn on the connected component.
• Refer to the operating instructions included

with the connected component and start
playing.

The sound is distorted.

• Adjust the recording level (see page 41).

Tuner

There is severe hum or noise (“TUNED” or
“STEREO” flashes).

• Set the proper band and frequency (see

page 7).

• Connect the antenna properly (see page 4).
• Find a place and an orientation that provide

good reception, then set up the antenna again.
If you cannot obtain good reception, we
recommend you connect a commercially
available external antenna.

• The supplied FM lead antenna receives

signals along its entire length, so make sure
you extend it fully.

• Locate the antennas as far away from the

speaker cords as possible.

• Consult your nearest Sony dealer if the

supplied AM antenna wire has come off the
plastic stand.

• Try turning off surrounding electrical

equipment.

continued

Advertising