Sony CMT-CP33MD - Manual (Page 17)

17
Basic Operations
Tips
• If you use a partially recorded MD, recording starts
after the recorded tracks.
• If the Smart Space function is on and there is no
sound input for about 3 seconds or more (but less
than 30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3 seconds
and continues recording. However, this function
may not activate if there is noise.
Note
If “Cannot SYNC” appears, a disc is not loaded or
you cannot record on that MD (see page 79).
If the MD becomes full during
recording
The tape deck and the MD deck stop
automatically.
Before pulling out the power
cord
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ? /1 to
turn off the system. Do not pull out the power cord
before updating the TOC (while “TOC” is lit) or
while updating the TOC (while “TOC” or
“STANDBY” is flashing) to ensure a complete
recording.
2
Press TAPE Z and insert a tape.
3
Press SYNCHRO REC repeatedly until
“TAPE-MD SYNC” appears.
4
Press ENTER/START.
The MD deck stands by for recording and the
tape deck pauses for play.
Tape playback side
>>> appears for the front side, and <<< for
the reverse side. To play the side not
indicated, press TAPE x and remove the
tape to reverse the tape side, then perform
steps 3 and 4 again.
5
Press ENTER/START again.
Recording starts.
When the recording is completed, the tape
deck and the MD deck stop automatically.
To stop recording
Press TAPE x or MD x.