Sony Ericsson XCI-V3 - Manual (Page 23)

23
External Control Commands
Note
The password entered is replaced with “*” on the
monitor.
When you enter the correct password, the following
message appears and the external command input is
validated.
Welcome to the Sony Smart Camera
Configuration Environment
When you enter a login account other than “admin” or
the wrong password, the following message appears.
Login incorrect
Note
If you enter the wrong password three times in a row,
the following message appears and the telnet
connection is disconnected.
Login incorrect
bye.
Depending on your telnet client software, this message
may not appear and the window may just close.
Multiple Session Specification
The XCI-SX1/V3 can be controlled via an RS-232C or
telnet connection asynchronously and can be
controlled via telnet in multiple sessions seperately.
1 Camera control device (e.g., PC) 1 SNMP Settings
2 RS-232C 2 Shutter Settings
3 XCI-SX1/V3 3 Time Settings
4 Telnet client
Command Format
To send a command, input a command name and
parameters and press [Enter] (<CR(Carriage Return)>
or <CR+LF(Line Feed)>) key.
Command inputs are echoed back to the 23rd port of
telnet/RS-232C except when the XCI-SX1/V3 is
transferring the LUT binary.
Notes
• Input characters are case-sensitive.
• Input decimal numbers for parameters.
• Maximum number of commands that can be input is
256 (except in Transparent mode).
Command Specification
The XCI-SX1/V3 returns an echo to valid inputs:
letters of the alphabet, numbers, “-,” spaces,
backspaces and [ENTER] (<CR> or <CR+LF>).
Input of letters and symbols other these above are all
ignored.
• When command execution is completed normally, the
response message to each command is displayed.
• If an invalid command is input, the following
messages are displayed.
error: invalid command or parameter.<CR>
Type ‘-
-help’ to display all possible
commands.<CR>
• When no parameter is input for a command with
parameters, the current status of the command is
displayed.
• When “- -help” is input instead of parameters for a
command with parameters, the help of the command
is displayed.
• When the Enter key is pressed with no command
input, only the carriage return is carried out.
The commands described in this chapter are valid
when the GUI application is operating.
1
2
3
1
2 3
4 4