Sony Ericsson XCI-V3 - Manual (Page 27)

27
External Control Commands
Camera Administrator: Pedestal Level
Setting
■ Pedestal Level Setting
[Command] pedestal LVL
[Parameter] LeVeL: 0 to 255 (1step)
[Process]
Sets the pedestal level.
<Example> Setting the pedestal level to 128
pedestal 128<CR>
camera pedestal complete<CR>
■ Auto Pedestal Level Settings
[Command] pedestal AUTO or pedestal AUTO
X Y
[Parameter] AUTO: auto
X: x-coordinate of the start point of the
rectangular area of the image data to
be used for adjustment
Y: y-coordinate of the start point of the
rectangular area of the image data to
be used for adjustment
*The size of the rectangular area of the
image to be adjusted is 160
× 128 for
the XCI-SX1 and 80
× 64 for the
XCI-V3. You are allowed to not input
the X and Y parameters. (When the X
and Y parameters are not input, the
rectangular area of the image data to
be used for adjustment is the center of
the image area.)
[Process] Adjusts the pedestal level
automatically.
<Example> Adjusting the pedestal level
automatically using the x-coordinate
and y-coordinate of the top left point
of the rectangular area
pedestal auto 560 448<CR>
camera pedestal complete<CR>
■ Current Pedestal Level Setting
[Command] pedestal
[Process]
Displays the current pedestal level.
■ Help of the Pedestal Level Setting
[Command] pedestal - -help
[Process] Displays the help of the Pedestal Level
Setting command.
Camera Shutter: Shutter Mode Setting
■ Shutter Mode Setting
[Command] shutter -m MODE
or
shutter soft
[Parameter] MODE: monitor, trigger
[Process] Sets the shutter mode and generates a
software trigger.
<Example> • Setting the shutter mode to monitor
mode
shutter -m monitor<CR>
camera shutter mode complete<CR>
• Generating a software trigger
shutter soft<CR>
camera shutter mode complete<CR>
Note
A software trigger function is valid only when the
shutter mode is set to trigger mode.
■ Current Shutter Mode Setting
[Command] shutter -m
[Process]
Displays the current shutter mode.
■ Help of the Shutter Mode Setting
[Command] shutter -m - -help
[Process] Displays the help of the Shutter Mode
Setting command.
Camera Shutter: Shutter Speed Setting
■ Shutter Speed Settings
[Command] shutter -s SPD
[Parameter] SPeeD: 2, 1, 1/15, 1/30, 1/60,
1/100, 1/120, 1/250, 1/500, 1/1000,
1/2000, 1/4000, 1/10000, 1/25000,
1/50000, 1/100000(t-width) [sec]
[Process] Sets the shutter speed.
<Example> Setting the shutter speed to 1/30 sec
shutter -s 1/30<CR>
camera shutter speed complete<CR>
■ Current Shutter Speed Setting
[Command] shutter -s
[Process]
Displays the current shutter speed.
Note
For the XCI-SX1, when the shutter speed is set to 1/
15 sec, the display depends on the shutter mode
currently set.
• When the shutter mode is set to “monitor”
shutter -s<CR>
shutter -s off<CR>
• When the shutter mode is set to “trigger”
shutter -s<CR>
shutter -s 1/15<CR>
■ Help of the Shutter Speed Setting
[Command] shutter -s - -help
[Process] Displays the help of the Shutter Speed
Setting command.