Sony Ericsson XCI-V3 - Manual (Page 31)

31
External Control Commands
Loading the Camera Settings
■ Loading the Camera Settings
[Command] load
[Process]
Loads the camera settings.
Note
After loading, the camera’s basic settings are
reconfigured (except for the CDS gain, pedestal
level, TRGINH and DMAINH).
Ethernet Mode Setting
■ Ethernet Setting
[Command] setup ether MODE
[Parameter] MODE: auto, 10half, 10full, 100half,
100full
[Process] Sets the ethernet mode.
<Example> Setting the ethernet mode to 100 Base
Half
setup ether 100half<CR>
setup save complete ether<CR>
warning: the network will be
restarted...<CR>
you may have to re-login if
you are linked via
telnet...<CR>
■ Current Ethernet Setting
[Command] setup ether
[Process]
Displays the current Ethernet mode.
■ Help of the Ethernet Setting
[Command] setup ether - -help
[Process] Displays the help of the Ethernet
Setting command.
Notes
• Reboot the XCI-SX1/V3 after changing the
ethernet setting.
• Set this to the same setting as the connected
network.
Ideal Figure of fps
■ Display the Ideal Figure of fps
[Command] fps VB HPS VPS HEND VEND
[Parameter] VB (Vertical Binning): 0[off],
1[on]
HPS (Horizontal Pertial Scan): 0[off],
1[on]
VPS (Vertical Pertial Scan): 0[off],
1[on]
HEND (Horizontal pertial scan END):
0-7
VEND (Vertical pertial scan END):
0-31
[Process] Displays the ideal figure of fps
according to the parameters.
<Example> Ideal fps: 29.30 of 1-1-1-7-31
(v-hs-vs-he-ve)<CR>
■ Current Ideal Figure of fps
[Command] fps
[Process]
Displays the ideal value of fps
according to the current register
setting.
■ Help of the Ideal Figure of fps
[Command] fps - -help
[Process] Displays the help of the Ideal Figure of
fps command.
Keyboard Setting
■ Keyboard Setting
[Command] setup kbmap TYPE
[Parameter] TYPE: en, jp
[Process]
Sets the keyboard map and preserve
the setting.
<Example> Setting the layout of the keyboard to
English and saving the setting
setup kbmap en<CR>
setup save complete kbmap<CR>
■ Current Keyboard Setting
[Command] setup kbmap
[Process]
Displays the current keyboard map
setting.
■ Help of the Keyboard Setting
[Command] setup kbmap - -help
[Process] Displays the help of the Keyboard
Setting command.
Camera TRGINH Setting
■ TRGINH Setting
[Command] trginh VALUE
[Parameter] VALUE: on, off
on: Invalidates the trigger.
off: Validates the trigger
[Process] Switches between invalidation and
validation of the trigger.
<Example> Setting the trigger to invalidation
trginh on<CR>
camera trginh complete<CR>
■ Current TRGINH Setting
[Command] trginh
[Process]
Displays the current trginh setting.