Southbend SB1023 - Manual (Page 30)

-28-
For Machines Mfg. Since 8/09 Model SB1023 O P E R A T I O N
Grinder Operation
Grinding with a surface grinder is a delicate
process that takes practice, skill, and knowledge.
In addition to this, the method used for any one
procedure will depend on a number of factors,
including, but not limited to the material being
ground, the grinding wheel being used, the
quality and calibration of measuring tools, and
the finish that is desired.
For these reasons, specific techniques are not
outlined in this manual. We recommend that you
consult books, trade magazines, metalworking
experts, and other reliable resources for
techniques pertaining to the specific tasks you
wish to perform.
The information that follows serves as a general
outline to help familiarize you with the basic
grinding technique.
Magnetic Chuck
The Model SB1023 is designed to be used with
a magnetic chuck. The table is equipped with a
T-slot for securing your magnetic chuck. Refer to
your magnetic chuck manufacturer's instruction
manual for proper chuck preparation and
mounting techniques.
A magnetic chuck secures workpieces to the table
without the use of clamps. With proper attention
to preparation of both the workpiece and the
magnetic chuck, a magnetic chuck will provide
ample clamping force on most magnetic metals.
Refer to your magnetic chuck manufacturer's
instruction manual for proper workpiece
mounting techniques.
Setup for a Typical
Grinding Operation
Once you have chosen the proper wheel for the
operation and properly installed the magnetic
chuck on the table, use the following procedures
to prepare for a grinding operation.
To prepare for a grinding operation:
1. DISCONNECT MACHINE FROM POWER!
2. To ensure flat mating surfaces on the
workpiece and the magnetic chuck, surface
grind and stone the top of the chuck and the
bottom of the workpiece.
3. Make sure the magnetic chuck is turned
OFF, then place the workpiece onto the
chuck. Once the workpiece is positioned as
needed, turn the magnetic chuck ON.
4. Make sure the grinding wheel is not
contacting the workpiece, connect the
grinder to power, then turn the motor ON.