Sanyo SRT-2400DC - Manual (Page 20)

NORMAL RECORDING
Normal Recording
Before starting
•
Turn the power on to all devices used.
•
Select the “TAPE” in the (SET UP 5) menu according
to the type of the tape used.
•
Load a cassette tape with erasure-prevention tab.
NOTE:
•
If in the (SET UP 3) menu, TAPE IN MODE is set
to “REC”, recording will start after the tape thread
has been checked.
•
Set the ON SCREEN switch to the “ON” position.
1
Press the REC/PLAY SPEED CHANGE button to set
the recording speed mode.
° The recording speed mode is displayed
on-screen and on the digital display.
2
Press the REC button.
° The record indicator “ a ” light.
° Recording starts.
° If the tape end is reached while recording, “OFF”
is displayed on the digital display and the unit
goes into the mode set at the “TAPE END
MODE” line in the (SET UP 3) menu.
NOTES:
•
If in the (SET UP 2) menu, in the BUZZER section
TAPE END is set to “Y”, the buzzer will be heard as
long as “OFF” is displayed on the digital display.
•
To cancel the “OFF” display, press the STOP,
EJECT, FF, REW or PLAY button.
3
To stop recording, press the STOP button.
NOTES:
•
A tape recording made on this VCR may not play back
with the same degree of clarity on a real time video
recorder from another manufacturer.
•
If you press on the REC button and the loaded cassette
has no erasure-prevention tab, the VCR will eject the
cassette.
[Recording Speed Mode]
(When “ TAPE” in the (SET UP 5) menu is set to
“ T-160” )
Recording
speed mode
(hour mode)
Maximum
recording
duration
(hours)
Recording
interval
(second)
Audio
recording
Tape motion
8 8 1/60
Possible Continuous 24 24 3/60
40 40 5/60
(When “ TAPE” in the (SET UP 5) menu is set to
“ T-120” )
Recording
speed mode
(hour mode)
Maximum
recording
duration
(hours)
Recording
interval
(second)
Audio
recording
Tape motion
6 6 1/60
Possible Continuous 18 18 3/60
30 30 5/60
NOTE:
•
The tape speed display will vary according to the
“TAPE” setting in (SET UP 5) menu setting. In this
manual, all the examples and displays used are for
when “TAPE” is set to “T-160”. If set to “T-120”, please
refer to the table above for the corresponding duration
and displays.
For example, if the recording speed mode is “8”, then
the corresponding recording speed when set to “T-120”
will be “6”. And, the counter reading of 7:57:00 will be
5:57:00 when set to “T-120”.
NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
English 19