Sanyo SRT-2400DC - Manual (Page 27)

ALARM RECORDING
Alarm Search
To go to the beginning of a desired alarm recording.
1
Press the PAUSE/SEARCH button during stop mode.
° “AL SEARCH 01” will be displayed on screen.
2
Press the l (or j ) button to set the desired alarm
number (1 to 99), then press the FF (or REW) button.
° The desired alarm is searched and a still image
of the beginning of the alarm recording will
appear on-screen.
NOTE:
•
The alarm number is relative to the actual tape
position. (Please refer to the illustration below.)
3
Press the PLAY button.
° Playback will start.
NOTE:
•
If during a search the end of the tape is reached, the
tape will rewind and stop. If the beginning of the tape is
reached, it will stop.
Alarm Scan
To look for an alarm recording by viewing the first 5
seconds of each alarm recording.
1
Press the PAUSE/SEARCH button twice during stop
mode.
° “AL SCAN” will be displayed on screen.
2
Press the FF (or REW) button.
° The unit will advance (or rewind) the tape at high
speed and playback the first 5 seconds of every
alarm recording.
° To cancel the alarm scan mode, press the STOP
button.
3
While the desired recording is being played back,
press the PLAY button.
° Playback will start, alarm scan mode is cancelled.
NOTE:
•
If during a scan the end of the tape is reached, the tape
will rewind and stop. If the beginning of the tape is
reached, it will stop.
Playback
1 1 2
Rewind direction Fast-forward direction
Actual position
Alarm number 2
Alarm trigger input point
NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
26 English