Sanyo SRT-2400DC - Manual (Page 33)

SERIES RECORDING
Continous Loop Recording Setup
A minimum of 2 units are required for continuous loop
recording.
Example with 2 VCRs.
Under loop recording when the recording finishes on the
first unit, the new recording will start on the second unit.
When the recording finishes on the second unit, recording
will start on the first unit.
1
The SERIES OUT/CLOCK OUT terminal of VCR
No.2 and the SERIES IN terminal No.1 should be
connected (See diagram).
2
Set the following items as indicated.
Item VCR No.1 VCR No.2
Cassette tape Loaded Loaded
Operation mode Stop Stop
“TAPE END MODE” (in
(SET UP 3) menu)
REW REW
“SERIES REC IN” (in
(SET UP 3) menu)
Y (YES) Y (YES)
“OUTPUT” (in (SET UP
5) menu)
SERIES SERIES
Security lock Canceled Set
3
Press the REC button on VCR No.1.
° Recording will start in series recording mode.
4
Set the security lock on VCR No.1.
NOTES:
•
To avoid recording problems, the “TAPE END MODE”
in (SET UP 3) menu should be set to “REW” for both
units.
•
In loop recording mode, the tape will be re-recorded
over. If you need to keep the recorded infomation,
please eject the tape after recording is complete and
insert a new tape.
Loop recording connection (example with 2 VCRs)
ALARM IN/
CLOCK IN COM ALARM OUT/
CLOCK OUT SERIES OUT/
NON REC OUT SERIES IN OUT IN EJECT SW
OUT
TAPE END OUT COM WARNING OUT COM
ALARM IN/
CLOCK IN COM ALARM OUT/
CLOCK OUT SERIES OUT/
NON REC OUT SERIES IN OUT IN EJECT SW
OUT
TAPE END OUT COM WARNING OUT COM
VCR No.2
Video camera
To
VIDEO IN
jack
To
VIDEO OUT
jack
VCR No.1
To
VIDEO IN
jack
To
VIDEO OUT
jack
To
SERIES IN
terminal
To COM
terminal
To
SERIES OUT
terminal
To COM
terminal
To
SERIES IN
terminal
Monitor TV
To
SERIES OUT
terminal
DC12V IN DC12V IN
NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
32 English