Star Micronics SP298 Series - Manual (Page 125)

122
APPENDIX
Paper Specifications
Paper Width 80 to 182mm / 3.15 ″ to 7.17 ″
Paper Length 80 to 257mm / 3.15 ″ to 10.8 ″
Copies Original + 2
Paper Thickness 1-ply: 0.09 to 0.2mm / 0.0035 ″ to 0.0079 ″
Duplicates 0.12 mm (minimum for 2-ply forms) to 0.25 mm/0.0047 ″ to 0.0098 ″
<Maximum 0.2 mm when printing graphics>
Copy Offset 1.5mm maximum/15 lines (between top sheet and bottom sheet)
Binding Top or left
Print Area
Distance from first printed line (Head #1) to top of form (form stopper): 28.6 mm
Distance from first printed line (Head #1) to TOF sensor: 26.0 mm
(However, with the automatic start position operation, this distance is set to 26.5 mm.
The automatic start position operation can be enabled or disabled with the memory
switches.
When the top-of-form sensor is disabled, a command can be used to perform a reverse
paper feed enabling printing to begin at approximately 20 mm from the top of the paper.)
Distance from last printed line (Head #9) to bottom of form (BOF sensor):
38.1 mm
(With the ESC/POS mode, printing may continue to 27.3 mm from the bottom of the
paper.)
When the BOF sensor is disabled, printing can continue to 14.0 mm from the bottom of
the paper.
Right margin:
5.1 mm
Print area width: 28.6 mm
Form stopper (fixed)
Head #1
Paper
Paper feed direction
Head #9
Paper feed
roller
14
BOF sensor (fixed)
TOF sensor (fixed)
3.2
5.1
26.0 28.6
11.9
38.1
62.7
2.82
Last printed line
First printed line
3.2
Units: mm