Siemens Gigaset SL 740 - Manual (Page 57)

56
Appendix
SL 740/SL 745 / IM-englisch / A31008-L740-N102-1-7619 / appendix.fm / 15.07.2004
Appendix
Care
Wipe the base and handset with a damp
cloth (use no solvent) or an antistatic
cloth. Never use a dry cloth. This can
cause static.
Contact with liquid
If the handset should come into contact
with liquid, switch it off. On no account
switch the device on. Remove the
battery immediately.
Allow the liquid to drain out of the device.
Then follow the instructions below:
1. Hold the device horizontally with the
open battery case facing down.
2. Hold the device vertically. Tilt the
device backwards and forwards
slightly, giving it a gentle shake each
time.
3. Pat all parts dry and keep the device in
a warm, dry place for at least 72 hours
with the battery compartment open
and with the keypad facing downwards
(do not place in a microwave, oven
etc.).
In many cases, you will then be able to use
it again.
Questions and Answers
If you have any questions about the use of
your phone, you can contact us around
the clock at www.siemens-mobile.com/
gigasetcustomercare. The following table
lists the most frequent problems and their
possible solutions.
!
The display is blank
1. The handset is not switched on.
£
Press the end call key a and hold.
2. The battery is flat.
£
Charge or replace the battery (p. 6).
The handset fails to respond to a key press.
Keypad protection is activated.
£
Press the hash key
#
again and hold
(p. 7).
"Base station x" flashes in the display.
1. Handset outside the base station range.
£
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
£
Register the handset (p. 40).
3. Base station is not activated.
£
Check the power connector at the base
station(p. 5).
Display flashes Base Search
The handset is set for Best Base, but no base
station has been activated or in range.
£
Reduce the distance between handset/base
station.
£
Check the power connector at the base
station (p. 5).
The handset does not ring
1. Ringer is switched off.
£
Activate the ringer (p. 48).
2. Call Diversion is set to All Calls.
£
Switch off Call Diversion (p. 13).
You cannot hear a ringer tone/ dial tone.
The base station telephone cable has been
replaced.
£
When purchasing a new cord ensure that it
has the correct pin connections (p. 6).
Your caller on the telephone cannot hear
you.
You have pressed the
9
key. This mutes the
handset.
£
Switch on the microphone again (p. 11).
The caller’s telephone number is not
displayed although CLIP is set.
Calling line identification is not enabled.
£
The caller should ask his network provider
to enable the identification of his number (CLI).