SharkRack KVM-8 - Manual (Page 13)

KVM-8 Installer/User Guide
6
Basic Installation
7
If you are using Remote Sun peripherals
3b. (This will require a VAK-1 adapter kit available from SharkRack.) If your monitor
uses a 13W3 plug, plug the 15HDD male adapter into the monitor port of your
Remote User Receiver and your monitor cable into your VAK-1 adapter. Otherwise
plug your monitor directly into the Remote User Receiver.
Plug the ends of the 8-pin mini-DIN male adapter into the keyboard and mouse
ports on your Remote User Receiver and then plug the Sun keyboard/mouse cable
into the VAK-1 adapter.
4. Connect the Category 5 cable to the modular jack on the rear of the Remote
User Receiver.
5. Connect the circular power plug from the wall mount power supply to the power
port on the Remote User Receiver. Then plug the power supply into a convenient
electrical outlet. Verify that the Remote User Receiverʼs POWER light is now lit.