SharkRack KVM-8 - Manual (Page 34)

KVM-8 Installer/User Guide
28
Channel Scanning
29
With the Scan button
1. You may initiate scanning by address by pressing and holding the Scan push-button
until the SCAN LED lights green.
2. Scanning may be halted if a channel is selected, or if the Scan push-button is
pressed again.
By keyboard hot-key sequence
The following key sequences control scanning.
Key Sequence Action
<CM>SG<Enter> Enables the scan Go command (By Address Only).
<CM>SH<Enter> Enables the scan Halt command.
Scanning by List
Scanning by list allows you to create a customized scanning order for the switch to
follow. Any active channel in the system can be scanned in any order, as many times
as desired.
To configure the scan list, open the main OSD window by pressing either of the
Control keys twice. Press them twice more to access the Command Menu. From the
Command Menu, use your arrow keys to highlight “Setup Scan List” and press the
Return key. This will activate the Administrator Scan List menu where you can add or
delete users from your custom scan list.
The Administrator Scan List Window
KVM Switch
Administrator Scan List
Address Dwell Name
ENTER - Save ESC - cancel
3 5 Mail Server
F2 - Add
4 5 Shop Floor
F3 - Delete
1 5 Sales
2 5 Accounting