Kenwood HM-535 - Manual (Page 18)

Playback of TAPE
18 EN
1. Load a cassette tape.
2. Start playback.
Press the TAPE 2 3 key.
To stop playback
Selection of TAPE equalizer (TAPE EQ.)
To wind tape
at high speed
Start playback
To wind tape at high speed
Playback of TAPE
÷ The tape deck of the unit can play Normal (Type ) tapes.
÷ When there is a tape slack, wind the tape before loading.
r
If you load a tape in the cassette deck in advance while the power is off, pressing the TAPE 2 3 key will
turns the power on automatically and starts the tape playback.
Displayed when the deck is loaded with a tape.
Reverse mode
indication
Transport direction indicators
Tape
counter
Do not use a cassette with more than 90-minute recording time, for the
tape used with such a cassette is very thin and tends to cause troubles
such as entanglement around the pinch roller or cutting off tape.
Transport direction indicators:
Indicates the tape transport direction during playback or recording by lighting
of
2 or 3. This direction is the direction stored in memory when the tape was
last stopped.
Start playback
To stop playback
1
Press the area marked ) push open to open the cassette holder.
2
Insert a tape.
3 Press the area marked ) push open to close the cassette holder.
5240/18-25/EN 3/9/02, 7:23 PM 18