Kenwood HM-535 - Manual (Page 29)

Various CD playback features
29 EN
Select "PGM" mode.
Select track numbers in the order you want to play them.
Start playback.
Select the CD input.
÷ Up to 32 tracks can be programed. When "PGM FULL" is
displayed, no more tracks can be programed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 200 minutes or
more, the time display shows "- - : - -".
1
Select the track.
2
Confirm the selection.
(Go to step
2
within 20 seconds.)
Press the numeric keys as shown below....
To select track No. 23 : +10 X 2, 3
To select track No. 40 : +10 X 4, 0
Various CD playback features
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
1
2
3
Program position of the track
to be selected next.
(To select more than one track, repeat steps 1 and
2 for each track.)
÷ Tracks will be played in the order they were pro-
gramed (following the program numbers).
÷ When the 4 key is pressed once during playback,
the track being played will be played from the
begining.
To skip further to a track preceeding the current track,
press the 4 key twice repeatedly.
÷ When the ¢ key is pressed during playback, play will
skip to the next track in the program.
Press in stop mode
Listening to the desired sequence
(program playback)
6
CD
SET
5
2
8
0
6
3
9
4
1
7
10
PGM
Selection of tracks
5240/29-32/EN 3/9/02, 7:24 PM 29