Kenwood HM-535 - Manual (Page 22)

Playback of TAPE
22 EN
One-by-one presetting (Manual preset)
1
Select the AUTO or MANUAL mode.
2
Tune a station.
Tuning to a non-preset radio station (Auto tuning, Manual tuning)
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good:
AUTO mode
When it is poor due to weak radio waves:
MANUAL mode
In AUTO mode :
The next preset station can be received automatically
every time the TUNING ( 1 or ¡) key is pressed.
In MANUAL mode :
Press the TUNING ( 1 or ¡) key repeatedly until the
desired station is received. The desired station can
also be received by holding the TUNING ( 1 or ¡)
key depressed until its frequency is displayed.
To increase
frequency To decrease
frequency
Each press alternates the mode.
1 "AUTO" :
Stereo reception ("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
1
Perform the procedure in "Tuning to a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2
Press the ENTER key during reception.
3
Select one of the preset numbers from
1 to 30.
4
Press the ENTER key again.
÷ In MANUAL mode, FM stations are received in mon-
aural.
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
÷ A maximum of 30 stations of the band presently be-
ing received will be preset.
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
÷ If several stations are preset under the same num-
ber, the previous memory is replaced with the latest
memory contents.
(Proceed to step 3 while "MEMORY" is lit.)
"MEMORY" lights (for approx. 20 sec.)
Receiving broadcast station
ENTER
5
2
8
0
6
3
9
4
1
7
10
4 4 P.CALL
1 1
TUNING
STOP 7
AUTO/MONO
ENTER
Remote control unit only
5240/18-25/EN 3/9/02, 7:23 PM 22