Konftel 300W - Manual (Page 12)

10
RECHARGinG bATTERiEs
The Konftel 300W lets you know when the battery’s remaining capacity is less than
one hour of talk time. An audible signal is emitted and the LEDs flash three times. The
battery recharging symbol on the display screen will also start flashing.
 Recharge the Konftel 300W by placing it on the charging stand.
 The battery can also be recharged by plugging the power cable into the Konftel
300W.
batteries
The battery has a button to display the battery’s remaining capacity.
The Konftel 300W comes with a charged battery, but it may need recharging to full
capacity depending on how long it has been in storage.
A fully-charged battery provides talk time of about 48 hours or 20 days of standby
time. The Konftel 300W automatically switches to sleep mode after a few minutes of
inactivity.
Warning!
• Do not attempt to open or modify the battery.
• Do not expose the battery to moisture or extreme heat.
• Extreme heat, short-circuiting or any attempt to modify the battery may cause it to
ignite or explode.
• Only use the battery provided or a Konftel-recommended replacement battery.
battery charger (optional)
The optional battery charger allows for external recharging of one or two batteries.
Charge status is denoted by the LED for each charging channel on the charger. The LED
is red during charging and green when the battery is fully charged. A red flashing LED
indicates that the battery is damaged and must be replaced.
GEnERAl