Conference guide settings, Displaying conference guide status, Conference guide – Konftel 300W User Manual
Page 23
21
ConfEREnCE GUiDE sETTinGs
When a multi-party call is going to be connected, a special signal (flash or R-pulse) is
produced which transmits the command (request, return and conference) to the PBX.
It may be necessary to change the type of signal if calls are connected via a PBX.
Different PBXs may require different signals. These requirements should be specified
in the technical data for the PBX. Settings for the most common PBXs are listed on
Konftel’s website.
Select
MEnU > Conf GUiDE > sETTinGs (3,6).
Enter the command for a request for a new dialling tone and press
oK to confirm.
(“F” is the default setting)
Enter the command to connect everyone to a multi-party call and press
oK to
confirm. (“F3” is the default setting)
Enter the command to return to your original call and press
oK to confirm. (“F” is
the default setting)
if you experience problems making multi-party calls
It may be necessary to change the duration of the pulse so that it works with your PBX.
Read “Adjusting Flash/R-pulse duration” on page 28.
Your PBX may not be programmed to admit multi-party calls or the procedure may be
different. Please contact your telephone administrator or service provider.
DisPlAyinG ConfEREnCE GUiDE sTATUs
Select
MEnU > Conf GUiDE > sTATUs (3,7).
The display screen indicates the number of conference groups already stored plus how many
more groups can be added.
ConfEREnCE GUiDE