Krown Manufacturing 2000DLD - Manual (Page 12)

GETTING STARTED (CONT.)
Phone Light Shows sounds heard on the telephone line.
Power Light Show status of power. When the light shows:
STEADY = Power is ON
FLASHING = Low battery power
NO LIGHT = Power is OFF
Power Switch: This switch turns the power ON and OFF
Print Switch: This switch turns the printer ON and OFF, it is not
available for MP2000DX and MP2000LD models. Turn printer
OFF and ON for these models by pressing [CTRL]-[P] instead.
ELECTRONIC VOICE
The electronic voice is a single programmable voice message that is stored in the memory of your
TDD. The message is used for calling hearing people at VOICE/TDD number. The TDD will also
send your state’s voice number, so the caller will know how to contact you. You must first program
this Voice Relay number by using [CTRL]+[K]. The voice message will be repeated until your TDD
conversation begins (when your TDD receives signals from another TDD or you type on the key-
board).
TO ENTER RELAY VOICE MESSAGE
The Memory Printer gives you one electronic voice message: “Please use TDD or Call through Relay.
X XXX XXX XXXX.” To enter your relay voice and TTY number:
TTY relay number’s stored.
Voice relay number’s stored.
To automatically dial the TTY relay number, press.
Clears the relay number you have stored.
10
CTRL + K TTY RELAY NUM
RETURN
VOICE RELAY NUM
CTRL R +
CTRL SHIFT + + R
RETURN
PLEASE WAIT. CHECK FOR DIAL TONE
DIALING XXX