Using the relay connector – Kenwood KVT-911DVD User Manual

Page 57

Advertising
background image

57

1. To prevent short circuits, remove the key from the

ignition and disconnect the

· terminal of the battery.

2. Make the proper input and output cable connections for

each unit.

3. Connect the wiring harness wires in the following order:

ground, battery, ignition.

4. Connect the wiring harness connector to the unit.

5. Install the unit in your car.

6. Reconnect the

· terminal of the battery.

7. Press the reset button. (See p. 4)

• If your car's ignition does not come with an ACC

position, connect the ignition wires to a power source
that can be turned on and off with the ignition key. If
you connect the ignition wire to a power source that
receives a constant voltage supply, as with battery
wires, the battery may die.

• If the fuse blows, first make sure that the wires have

not caused a short circuit, then replace the old fuse
with one with the same rating.

• Do not let unconnected wires or terminals touch

metal on the car or anything else conducting
electricity. To prevent short circuits do not remove the
caps from unused terminals or from the ends of the
unconnected wires.

• After the unit is installed, check whether the brake

lamps, blinkers, wipers, etc. on the car are working
properly.

• Insulate unconnected wires with vinyl tape or other

similar material.

• Thoroughly wipe away oil and other dirt from the

installation surface.
Please avoid installation on uneven surfaces.

• Mount the unit so that the mounting angle is 30° or

less.

• Do not install the receiver unit under the carpet.

Otherwise heat build-up occurs and the unit may be
damaged.

2CAUTION

Installation Procedure

Using the Relay Connector

(Accessory G)

Plug the vehicle's harness into
the relay connector.

Plug the parking brake detection
wire into the relay connector.

Lock the cable clamp.

Press down using pliers until
the conductive metal is even
with the plastic surface.

Lock the lid.

5

4

3

2

1

1

2

Detection wire

Vehicle
harness

3

Relay
connector

4

5

Cable clamp

Lid

Conductive metal

KVT_911DVD_Eng_01 02.1.25 2:25 PM Page 57

Advertising