Kenwood KVT-911DVD - Manual (Page 58)

FM /AM
ANTENNA AV INPUT
AV INPUT
L R
L R
1
2
VIDEO
VIDEO FRONT REAR
PREOUT
NON-FAD
AV OUTPUT POWER
TO MONITOR UNIT
L R
L R
VIDEO
L L L
R R R
ANT
CONT
P.CONT
ILLUMI
EXT.CONT.
( 3A )
( 10A )
A
B
C
ILLUMI
PRK SW
M 4
( 5A )
A
B
C
58
Installation
Connection
+
A
B
C
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may start a fire. Always connect those wires to the
power source running through the fuse box.
2WARNING
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main fuse)
ACC
Car fuse box
Battery
When using the optional power amplifier, connect to its power
control terminal.
To car light control switch
Depending on what antenna you are using, connect either to
the control terminal of the motor antenna, or to the power
terminal for the booster amplifier of the film-type antenna.
To "EXT.AMP.CONT." terminal of the amplifier having the
external amp control function.
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange)
External amplifier control wire (Pink / Black)
To car light control switch
Dimmer control wire (Orange)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Wiring harness
(Accessory A)
(Accessory C)
(Accessory B)
(Accessory E)
(AccessoryF)
Receiver unit (front side)
Monitor unit
Connect to the vehicle's parking brake detection switch
harness using the supplied relay connector.
For the sake of safety, be sure to connect the parking sensor.
2 CAUTION
Parking sensor wire (Green)
Black
KVT_911DVD_Eng_01 02.1.25 2:25 PM Page 58