Kenwood KVT-911DVD - Manual (Page 62)

62
Installation
Attach the installation brackets to the sides of the
hideaway unit using the sems bolts (M4
× 8 mm).
Use the tapping screw (ш4 Ч 16 mm) to secure the
hideaway unit to the audio board.
2 1
Securing to audio board
■
;;;;;;
;;;;;;
Sems bolts (M4 × 8 mm)
(Accessory N
Tapping screw (ш4 Ч 16 mm)
(Accessory O) Installation brackets
(Accessory M)
Installation for Receiver unit
Installation for Monitor Unit
• When mounting the main unit after checking the operation, close the monitor first.
• During installation, do not use any screws except for those provided. The use of different screws might result in
damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with excessive force during the installations.
Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction.
NOTE
2 CAUTION
Accessory I Metal mounting strap
Self-tapping screw
(commercially available)
Firewall or metal support
Accessory H Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
6 mm
MAX.
ø5mm ø5mm
6mm
MAX.
Installing in Japanese-Made Cars
■
T: Toyota cars
N: Nissan cars
T
N
N
T
T/N
Accessory K...for Nissan car
Accessory L ...for Toyota car
Refer to the section "Removing the hard
rubber frame (P.63)" and then remove the
hard rubber frame.
Align the holes in the unit (two locations on
each side) with the vehicle mounting bracket
and secure the unit with the accessory
screws. 2
1
K
L
Optical cable (Provided with the KDS-P900/P901)
When handling an optical cable for wiring, use care not to exceed the
minimum cable bend radius of 30 mm. If you exceed the minimum
bend limit, optical fibers within the optical cable may be damaged.
When installing the DVD player unit on the vehicle, ensure that the
optical cable is not stuck between the DVD player unit and vehicle
parts.
2 CAUTION
KVT_911DVD_Eng_01 02.1.25 2:25 PM Page 62