Kodak ESP 5200 - Manual (Page 11)

Networking Your Printer
6 www.kodak.com/go/aiosupport
The Wi-Fi connectivity LED blinks as the printer searches for available wireless
networks within range, then displays the list in order of signal strength. For
example:
If there are additional networks than can be shown on the LCD, press to view
them. If you don’t see your network in the list, or if you want to change your
network, select
Rescan for Wireless Networks, then press OK.
4. If the name of your network is:
5. If your network has security enabled, use the LCD keyboard (see Using the LCD
keyboard, page 8 ) to enter your security string.
6. When the confirmation message appears, press OK.
If the printer is successfully connected, the Wi-Fi connectivity LED stops
blinking and remains lit.
7. If you haven’t yet installed the KODAK All-in-One Printer Software, go to
www.kodak.com/go/esp5250downloads or
www.kodak.com/go/esp5210downloads , and follow the on-screen instructions
to install the software.
The printer with a wireless connection is listed as the name of the printer plus a
number (for example, KodakESP5200+1133).
Listed Not listed
Press to select your
network, then press OK .
Make sure your wireless router is turned on and
within range. If your wireless router does not
broadcast its SSID (network name):
1. Press to select Unlisted Network, then press
OK.
2. Use the LCD keyboard (see Using the LCD
keyboard, page 8 ) to enter your network name.
3. Select WEP or WPA/WPA2 as required for your
network's security setup, then press OK.