Konica Minolta Dimage A1 - Manual (Page 59)

59
EXPOSURE AND FLASH COMPENSATION
The ambient light and flash exposure can be adjusted before the image is captured to make the final
picture lighter or darker. Exposure can be adjusted by as much as ±2Ev in 1/3 increments (p. 111).
The exposure and flash compensation will remain in effect until it has been reset. For more on expo-
sure compensation, see page 110.
Adjustments to exposure must be set before the image is captured. When setting exposure or flash
compensation, the change in Ev is shown on the data-panel aperture display and on the monitors.
After the setting is made, the shutter-speed and aperture displays will indicate the actual exposure.
Flash compensation
Exposure compensation
Press the exposure compensation button (1).
Use the front control dial (2) to set exposure compensa-
tion.
Use the rear control dial (3) to set flash compensation.
Press the shutter-release button partway down or press
the exposure-compensation button to complete the oper-
ation. The values will automatically be set if a change is
not made for a few seconds. If any other value except 0.0
was set, an indicator will be displayed on the monitor as a
warning.
1
2
3