Kenwood XD-A900 - Manual (Page 31)

XD-951/A900/A700 (En)
31
Preparation section
Application section
Knowledge sections
Basic section
CD RECORD
CD EDIT
CD PGM RECORD
TAPE DUBBING
Copying tape
(Tape dubbing)
The contents of the tape in deck A can be copied onto the
tape in deck B.
The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on
deck A.
Note Note
÷ The deck B will stop after creating a non-recorded portion of about
4 sec, and then the deck A will stop.
÷ Dubbing can also be stopped by pressing the stop (7) key. Note that
the non-recorded space is not created in this case.
To stop dubbing
1Select the “TAPE” input.
2Press the stop key.
3Select “[” (double-side recording)
or “ “” (one-side recording).
4Press the DUBBING key.
5Select “TAPE DUBBING” and press
the SET key.
6Use the same tape transport direc-
tions.
(1) Select the transport direction of
deck A.
(2) Select the transport direction of
deck B.
7Start dubbing.
Let's record
Load tapes in the decks.
Playing tape Recording tape
÷ When recording is started, the tape will be transported in the direction
selected in this step.
Check the tape transport direction
indicators.
÷ By selecting “RETURN” and pressing the ENTER key, the operation
returns to the previous step so the current step can be restarted.
÷ Dubbing ends automatically when the side(s) to be dubbed has been
completed.
A A
INPUT
REV.MODE
DUBBING
D U B B I E P A T
MULTI
CONTROL
SET
MULTI
CONTROL
ENTER
REC/ARM
| Scrolled display
(TAPE DUBBING)
R FW D I D A
B DIR FWD
B DIR RVS
RETURN
A DIR FWD
A DIR RVS
1. Select. 2. Press SET.
MULTI
CONTROL
SET
1. Select. 2. Press SET.